Marine fish, corals and invertebrates can be sensitive to sudden changes in temperature, salinity, pH and water chemistry.
Correct acclimation reduces stress and gives new livestock the best chance of adjusting safely to your aquarium.
Different species may require different methods, so always follow any specific advice provided by Roxy Aquarium at the time of purchase.
Before bringing marine livestock home
Make sure the aquarium is ready before purchasing.
Check:
- The aquarium is fully cycled
- Ammonia is 0 ppm
- Nitrite is 0 ppm
- Nitrate is appropriate for the livestock
- Temperature is stable
- Salinity is stable
- pH is suitable
- Filtration and circulation are operating
- Tank mates are compatible
- Lighting is appropriate
- Quarantine equipment is available where possible
Do not purchase marine livestock for an aquarium that has only just been set up.
Test your aquarium first
Before acclimation, confirm:
- Temperature
- Salinity or specific gravity
- pH
- Ammonia
- Nitrite
- Nitrate
For reef aquariums, you may also need to monitor:
- Alkalinity
- Calcium
- Magnesium
- Phosphate
The correct levels depend on the livestock being kept.
Stability is extremely important in marine aquariums.
Keep transport time as short as possible
After collecting livestock:
- Travel directly home
- Keep bags upright
- Use an insulated container
- Keep livestock away from direct sunlight
- Avoid excessive heat or cold
- Do not open bags during transport
- Avoid shaking or unnecessary handling
Tell our team when you have a long journey so suitable packing can be considered.
Prepare the aquarium before opening the bag
Before beginning acclimation:
- 1Turn off or dim the aquarium lights.
- 2Prepare a clean bucket or container used only for aquarium livestock.
- 3Have clean airline tubing ready if drip acclimation is required.
- 4Prepare a fish net or suitable specimen container.
- 5Make sure pumps and equipment are operating correctly.
- 6Keep pets and children away from the acclimation area.
Avoid starting acclimation before the final aquarium location is ready.
Important warning about transport water
Transport water can contain:
- Fish waste
- Ammonia
- Medication
- Parasites
- Bacteria
- Other contaminants
Do not pour transport water into your display aquarium.
Use a net, specimen container or another suitable method to transfer livestock.
Temperature acclimation
For many marine fish and invertebrates, begin by floating the sealed bag in the aquarium for approximately 15–20 minutes.
This helps the temperature inside the bag gradually move closer to the aquarium temperature.
Do not leave the sealed bag floating for an excessive period.
After a long journey, speak with our team about the best method before opening the bag, as accumulated waste and changing pH can affect ammonia toxicity.
Acclimating Marine Fish
Marine fish may be acclimated using either a controlled bag method or drip acclimation, depending on:
- Species sensitivity
- Travel duration
- Difference in salinity
- Difference in pH
- Fish condition
- Whether copper or medication may be present in transport water
Basic bag acclimation method
For hardy marine fish and short transport periods:
- 1Float the sealed bag for approximately 15–20 minutes.
- 2Open the bag carefully.
- 3Add a small amount of aquarium water.
- 4Wait approximately 5 minutes.
- 5Repeat several times.
- 6Transfer the fish without adding bag water to the aquarium.
- 7Keep the lights dim.
- 8Monitor breathing and behaviour.
Do not extend the process unnecessarily.
Drip acclimation method
Drip acclimation may be recommended for sensitive fish or when salinity differs significantly.
To drip acclimate:
- 1Place the livestock and transport water into a clean aquarium-only container.
- 2Use airline tubing to siphon water from the aquarium.
- 3Tie a loose knot or use a valve to control the flow.
- 4Begin with a slow drip.
- 5Gradually increase the water volume in the container.
- 6Monitor temperature and livestock condition.
- 7Transfer the livestock without adding acclimation water to the display aquarium.
The appropriate drip rate and duration depend on the species and water difference.
Do not leave livestock unattended during acclimation.
Check salinity differences
A large difference in salinity can cause osmotic stress.
Measure both:
- Aquarium salinity
- Transport-water salinity
Where possible, use a calibrated refractometer or another suitable marine salinity tester.
Do not rapidly raise or lower salinity.
Fish arriving from lower salinity may require a slower adjustment to reef-level salinity.
Do not rely only on hydrometer readings
Swing-arm hydrometers can become inaccurate because of:
- Salt buildup
- Air bubbles
- Poor calibration
- Temperature
- Residue
Rinse testing equipment after use and check calibration regularly.
A refractometer should also be calibrated with an appropriate solution.
Acclimating Corals
Corals may be stressed by:
- Temperature changes
- Salinity changes
- Different lighting intensity
- Water-flow changes
- Handling
- Pests
- Shipping conditions
Acclimation should include both water adjustment and gradual light adjustment.
Basic coral acclimation
- 1Float the sealed bag for approximately 15–20 minutes.
- 2Transfer the coral and bag water into a clean container.
- 3Gradually add aquarium water.
- 4Inspect the coral carefully.
- 5Perform an appropriate coral dip where suitable.
- 6Rinse the coral in a separate container of clean aquarium water.
- 7Place the coral in a lower-light area initially.
- 8Gradually move it to its intended position.
Do not pour coral transport or dip water into the aquarium.
Coral dipping
A coral dip may help reduce the risk of introducing some pests.
However:
- Different coral dips target different pests
- Not every coral tolerates every dip
- Dipping does not guarantee the coral is pest-free
- Coral dip is not a substitute for quarantine
- The product instructions must be followed carefully
Never dip fish in a coral dip.
Do not dip corals in freshwater unless specifically recommended for that species and situation.
Inspect corals for pests
Before placing a coral into the display aquarium, check for:
- Flatworms
- Nudibranchs
- Eggs
- Aiptasia
- Vermetid snails
- Algae
- Crabs
- Damaged or dying tissue
- Unwanted hitchhikers
Use bright lighting and inspect the underside, frag plug and crevices.
Where possible, remove or replace contaminated frag plugs.
Light acclimation for corals
Corals may bleach or become damaged when moved suddenly into much stronger lighting.
To reduce light shock:
- Start the coral lower in the aquarium
- Reduce lighting intensity temporarily
- Use an acclimation mode where available
- Shorten the photoperiod initially
- Move the coral gradually over several days or weeks
- Observe colour and polyp extension
Do not assume a coral needs maximum light immediately.
The correct placement depends on the coral species and your lighting system.
Flow acclimation for corals
Different corals prefer different levels of water movement.
Too much flow may cause:
- Tissue damage
- Failure to open
- The coral being blown from its position
- Constant retraction
Too little flow may cause:
- Debris buildup
- Poor gas exchange
- Reduced feeding
- Tissue problems
Begin with moderate, indirect flow unless the species requires otherwise.
Adjust based on the coral’s response.
Acclimating Shrimp and Other Invertebrates
Marine shrimp, snails, starfish, urchins and other invertebrates can be very sensitive to sudden changes in salinity and pH.
Drip acclimation is commonly recommended.
General invertebrate acclimation
- 1Float the sealed bag to equalise temperature.
- 2Place the livestock and transport water into a clean container.
- 3Slowly drip aquarium water into the container.
- 4Monitor the animal closely.
- 5Transfer it gently without adding transport water to the aquarium.
- 6Keep lighting low.
- 7Observe it for signs of stress.
Avoid exposing sensitive invertebrates to air unless the species can safely tolerate it.
Starfish and sensitive invertebrates
Some starfish and other invertebrates are particularly sensitive to salinity changes.
They may require:
- Very slow acclimation
- Stable temperature
- Stable salinity
- Mature aquarium conditions
- Careful handling
- Minimal air exposure
Speak with our marine team before purchasing sensitive invertebrates.
Acclimating Anemones
Anemones require stable aquarium conditions and are not suitable for newly established marine tanks.
Before adding an anemone, confirm:
- The aquarium is mature
- Salinity is stable
- Lighting is suitable
- Flow is appropriate
- Temperature is stable
- Powerhead intakes are protected
- Tank mates are compatible
Anemones may move around the aquarium until they find a suitable location.
Do not force an anemone into a position or repeatedly move it.
Protect pumps and overflows
Anemones and other mobile invertebrates can be injured by:
- Powerhead intakes
- Overflow teeth
- Uncovered pumps
- Strong suction
Use suitable guards where necessary.
Quarantine is strongly recommended
A separate quarantine aquarium helps reduce the risk of introducing:
- Marine ich
- Velvet
- Flukes
- Bacterial infections
- Coral pests
- Unwanted hitchhikers
Quarantine also allows you to:
- Observe feeding
- Monitor behaviour
- Treat disease
- Reduce competition
- Confirm the animal is stable
Quarantine requirements differ for fish, corals and invertebrates.
Do not use copper medications in a system containing corals or invertebrates.
Never add store water to your aquarium
Even when livestock appears healthy, transport water should not be added to the display tank.
Transfer fish with a net or specimen container.
For corals and invertebrates, use separate rinse water before placement.
Keep the lights dim after introduction
New marine livestock may be stressed by bright lighting.
After introduction:
- Keep lights dim or off for several hours
- Avoid sudden movement near the aquarium
- Do not immediately feed heavily
- Watch for aggression
- Check breathing
- Confirm the animal is not trapped near pumps
Corals should be gradually acclimated to lighting intensity.
When should marine fish be fed?
Allow the fish time to settle.
Depending on the species and time of introduction, offer a small amount later in the day or the following day.
Use food suitable for the species.
Remove uneaten food promptly.
Some marine fish have specialist feeding requirements and may need:
- Frozen food
- Algae-based food
- Live food
- Multiple small meals
- Target feeding
Ask our team about feeding before purchase.
Watch for aggression
Marine fish may become territorial toward new arrivals.
Look for:
- Continuous chasing
- Biting
- Fin damage
- A fish trapped in a corner
- A fish unable to feed
- Aggression from similar species
- Attacks near caves or territory
An acclimation box may help when introducing certain fish.
Rearranging rockwork can sometimes reduce established territories.
Signs of stress after introduction
A newly introduced marine fish may temporarily:
- Hide
- Lose colour
- Refuse food
- Breathe slightly faster
- Remain near rockwork
- Swim cautiously
These signs should gradually improve.
Contact Roxy Aquarium promptly when you notice:
- Severe or continuous gasping
- Loss of balance
- White spots or heavy dusting
- Scratching
- Rapidly worsening colour
- Visible injuries
- Continuous aggression
- The fish lying on its side
- A coral rapidly losing tissue
- An invertebrate becoming unresponsive
Do not add medication directly to the display tank
Before treating marine livestock:
- Identify the likely problem
- Confirm the treatment is suitable
- Check whether it is safe for corals and invertebrates
- Consider using a hospital aquarium
- Follow the product instructions
- Test water quality first
Copper and many other medications are unsafe for invertebrates and reef aquariums.
Do not make several changes at once
When new livestock appears stressed, avoid simultaneously changing:
- Salinity
- Temperature
- pH
- Lighting
- Flow
- Medication
- Food
- Aquarium layout
Multiple sudden changes can create additional stress and make the original problem harder to identify.
A simple marine acclimation checklist
Before introducing new livestock:
- Test the aquarium water
- Confirm stable temperature and salinity
- Dim the lights
- Prepare clean acclimation equipment
- Float the sealed bag
- Compare salinity where possible
- Use gradual or drip acclimation when appropriate
- Do not add transport water to the aquarium
- Inspect and dip corals where suitable
- Place corals in lower light initially
- Monitor aggression and breathing
- Keep quarantine available
Need help with marine acclimation?
Contact or visit Roxy Aquarium and provide:
- The fish, coral or invertebrate species
- Aquarium size
- How long the aquarium has been running
- Temperature
- Salinity
- pH
- Ammonia
- Nitrite
- Nitrate
- Alkalinity where relevant
- Current tank mates
- Travel time
- Photos or videos of the livestock
Our marine team can recommend a more suitable acclimation method for the specific species.